Bevel gears are conical gears that are conical, used for transmission of two vertical shafts, but are also suitable for transmission of two shafts at other angles. Normally, a horizontal drive device is used to drive a vertical pump. Bevel gears have a wide range of uses, especially when the two shafts intersect, the distance between the two shafts is very close, the transmission power is large, and the rotation ratio is fixed, the bevel gear is most suitable.
Nylon products have many advantages, such as good performance in impact resistance, wear resistance and fatigue resistance. Therefore, nylon gears are widely recognized and welcomed by consumers in the market. It should be noted that nylon products have been used for nearly 30 years in helical gears, worm gears, spur gears and helical gears.
Compared with ordinary nylon, MC nylon has much higher physical and mechanical properties than ordinary nylon.
As we all know, in the design of industrial injection molding products, the use of ultrasound is one of the highlights of product design and assembly. Many product designs need to use assembly buckles, but because the buckle assembly sometimes has problems with tightness, resulting in products Will not perform well enough in terms of waterproofing!
How to control the temperature during injection molding？
2K molding is mainly carried out by two-color molds through two-color injection molding machines. we has several two-color injection molding machines to meet the demand for more diversified, high-quality, and high-value-added products. So how do you compare with traditional injection molding, what are the advantages of two-shot injection molding at one time? Let's follow the editor of Machke to understand the following points.
