PEEK fittings Manufacturers

Reasonable mold structure. The principle of mold design is to ensure sufficient strength, rigidity, concentricity, neutrality and reasonable blanking gap, and reduce stress concentration to ensure that the parts produced by the mold meet the design requirements, so the main working parts of the mold (such as The convex and concave dies of the punching die, the movable and fixed dies of the injection mold, the upper and lower dies of the die forging die, etc., require high guiding precision, good concentricity and reasonable blanking clearance.

Compared with PTFE, the advantages of PEEK material are high strength, good wear resistance, high mechanical strength at high temperature, dimensional stability, good creep resistance, and injection molding.

Injection molding factories often encounter products with insufficient gloss when processing injection molded parts. Low gloss means the surface is dark and dull, and the transparency of transparent products is low. There are many reasons for poor gloss. General product surface gloss defects can be divided into the following three types: mold failure, improper molding conditions, improper use of raw materials.

Plastic mold processing is widely used in the plastic product industry and has a history of development for many years. However, there are still some plastic mold processing manufacturers that have product color differences when processing molds

Drill bit is a kind of commonly used hardware tool products. Although the size of the drill bit is relatively small, it cannot be separated from the modern industrial construction industry. The drill bit also needs to pay attention to some matters during the use process, so as to ensure that it can be used normally at the same time. , It can also ensure its safety in use. What are the precautions for the use of drill bits?

What factors affect the chemical resistance of PEEK rods: Important influencing factors include: continuous working temperature, mechanical load, climate influence, fire performance requirements and electrical conductivity.