Vespel SP-1 PI sheet Manufacturers

The English name of PEI Chinese polyetherimide board is Polyetherimide, PEI belongs to amorphous plastics. It is an amorphous high-performance polymer, which is extruded from engineering plastics made of amorphous PEI (polyetherimide) at high temperature by an extruder. At present, the commonly used PEI board is the raw material (Ultem) of GE in the United States. In 1972, GE of the United States began to research and develop PEI.

The cooling time of the part usually refers to the period of time from when the plastic melt fills the cavity of the injection mold until the part can be opened and taken out. The time standard for taking out the part by opening the mold is often based on the part that has been fully cured, has a certain strength and rigidity, and will not be deformed and cracked when the mold is opened and ejected.

PPSU (Chinese name: Polyphenylsulfone) is a high temperature resistant plastic with obvious advantages. Compared with other transparent plastics, it has higher toughness, strength and hydrolytic stability, and can withstand long-term exposure to water, chemicals and a wide working environment temperature of -40℃-180℃.

Semitron, as an important semiconductor material that uses synthetic mica to enhance the technical effect, can rely on various component forms to help improve the operation efficiency of the production line in specific application fields. Many users who have industrial production and construction requirements will rely on the components of this material to carry out corresponding activities to improve efficiency such as controlling electrostatic discharge after clarifying the physical properties of the material.

WPC metal finish is effective on all surfaces inside and outside the machine where increased strength is required. This is especially effective for sliding surfaces and machine parts that require lubrication. If the WPC metal surface treatment process is carried out on a variety of machines with high friction, the machine will feel better. Because WPC metal finishing is not a new technology developed for an industry, it is not widely known. However, people gradually realized that it could increase strength and make parts compact.

The peek material can be injection molded. PEEK is a high-temperature special engineering plastic and needs to be maintained at about 350 degrees. This requires the heating section of the injection molding machine barrel to continuously and stably provide a heating temperature above 350 degrees. The melting temperature of the peek material at high temperature is relatively high, and the viscosity in the molten state is relatively large, and the pressure required for injection molding is higher, and the wear of the screw is greater. In addition, peek injection molding requires heating, which is different from ordinary injection molding. It is recommended to find a manufacturer that specializes in peek injection molding to avoid certain technical risks.